I have problem about generating Pick and Place file. The value of Center-Y is bigger than the board Y size, how can I fix this problem?
After spent some hot surfing, found http://wiki.altium.com/display/ADOH/Preparing+the+Board+for+Design+Transfer said Moving the Board Shape which I think that I successfully moved the board into origin point then go for generating pick and place file.
From Design > Board Option to check current sheet position. My sheet position is X: 25.4mm, Y:25.4mm, Width: 254mm, Height: 203.2mm.
Then follow instructions above to use Move Board Shape to move shape to oringin (0, 0). Select Edit » Move » Move Selection by X, Y, then enter X: -25.4mm, Y:-25.4mm.
No comments:
Post a Comment