Got instructions from Xiangfu:
1. http://en.qi-hardware.com/wiki/Reflash_ben.sh
2. You can use:
tail -f ${HOME}/.qi/nanonote/bne/latest/log.txt
It will keep you the status updated.
P.S.:
1. If at the end of log of flashing it shows:
Now checking whether all configure args valid: YES
Current device information:
CPU type is Ingenic XBurst Jz4740
Crystal work at 12MHz, the CCLK up to 252MHz and PMH_CLK up to 84MHz
SDRAM Total size is 32 MB, work in 4 bank and 16 bit mode
Nand page per block 128, Nand page size 4096, ECC offset in OOB 12, bad block offset in OOB 0, bad block page 127, use 1 plane mode
Execute command: reset
command not support or input error!
done
2. means that your xburst-tools is old version. 'reset' is just to reboot the NanoNote. The newest version is here:
http://projects
1. http://en.qi-hardware.com/wiki/Reflash_ben.sh
2. You can use:
tail -f ${HOME}/.qi/nanonote/bne/latest/log.txt
It will keep you the status updated.
P.S.:
1. If at the end of log of flashing it shows:
Now checking whether all configure args valid: YES
Current device information:
CPU type is Ingenic XBurst Jz4740
Crystal work at 12MHz, the CCLK up to 252MHz and PMH_CLK up to 84MHz
SDRAM Total size is 32 MB, work in 4 bank and 16 bit mode
Nand page per block 128, Nand page size 4096, ECC offset in OOB 12, bad block offset in OOB 0, bad block page 127, use 1 plane mode
Execute command: reset
command not support or input error!
done
2. means that your xburst-tools is old version. 'reset' is just to reboot the NanoNote. The newest version is here:
http://projects
No comments:
Post a Comment